![]() The other switch must be a standard two way switch, and this will turn the light on and off at the level set by the dimmer switch.ĭANGER Dimmer switches should NOT be installed in stairways, as dimly lit stairs are just waiting for people to trip and fall down them. It is possible to have a dimmer switch on a two way circuit, but you can only have ONE dimmer. The wiring in your home is likely to require replacement, as lighting circuits have been installed with earth wires for over 40 years. If you have old cables without earth wires, you must NOT install any metal switches or light fittings. The earth wires in the cable are bare copper, and must be covered with green/yellow striped sleeving. Two core cable - old and newīlack = Blue Three core cable - old and newĪll of these switch wires are live, so red sleeving is used on the black, blue and yellow wires. ![]() Prior to 2005, three core and earth cable contained red, yellow and blue wires. ![]() This is essential, as without an earth connection, the metal plate could become live in the event of a fault. Metal switches are connected in exactly the same way, but the earth wires connect to an earth terminal on the switch plate. The light can be switched on or off from either switch. This arrangement is often found in stairways, with one switch upstairs and one switch downstairs. COM on the first switch connects to COM on the second switch, L1 to L1, and L2 to L2.Īll of the earth wires connect to a terminal in the backbox, or alternatively to a separate earth connector. This three core cable connects the two switches together. This contains brown, black and grey wires, but as with other switches, all of these wires are live, so brown sleeving should be placed over the black and grey wires. A three core and earth cable is typically used. The second switch is connected to the first switch using three wires. This is the cable entering from the top of this diagram. The difference is that one wire connects to L1 and the other to L2. Two way switching - Plastic switchesīoth switches must be of the two way type, and will have three terminals.Īs with the one way switch, the switch cable from the ceiling rose contains two wires, a permanent live and a switched live. It is also an easy way to add a second switch to an existing circuit. This is a common method of providing two switches to control one light. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |